I was able to verify with Roadmaster for you the correct fit for your 2020 Tiffin Allegro Open Road 36UA motorhome, which is the following:
- Roadmaster Exact Center Steering Stabilizer # RM62RR
The # RM62RR consists of the stabilizer and custom mounting brackets that fit your Tiffin motorhome; this will give you much better overall responsiveness when steering your rig for a more comfortable ride. view full answer...
Manufacturers do not list the fireplaces they use for the public so the only way to know what would fit would be to actually measure the cutout hole or find the serial number on the back of your current fireplace so that we can determine the dimensions.
For example the Furrion RV Electric Fireplace with Logs # F30SW15ABL you were looking at has an overall dimension of 29-15/16" wide x 17-3/4" tall x 6-1/4" deep but will fit a wall cutout of 26-1/4" wide x 16-1/4" tall x 5" deep. view full answer...
The Curt Echo Wireless Trailer Brake Controller # C51180 is a universal brake controller and will work on most any vehicle that has a 7-way plug that is wired properly and operational. For that reason I do not see any issues with why it will not fit your 2021 Tiffin Open Road Allegro Motorhome.
To ensure that you will not have fitment issues the Echo is 6-5/8" long. You can check where the Echo will plug in on your 2021 Tiffin to ensure there will not be any clearance issues. Also depending... view full answer...
The closest Go Power option to the Magnum Energy MM1212 Inverter Charger is the Go Power Industrial Pure Sine Wave Inverter Charger # 34280055. This inverter/charger is rated for 2000 watts running and 4,000 watts surge/startup. This equals out to about 17 amps continuous and up to 35 amps surge. The charger side of this unit will pull 15 amps AC and output up to 100 amps DC.
This unit is Pure Sine Wave, making it safe for sensitive electronics unlike the Modified Sine Wave of the Magnum... view full answer...
If the filter on your Valterra RV Vent Ceiling Register # A10-3361VP is dirty it is possible to remove and wash the existing filter. Unfortunately, a replacement filter is not something that is offered. If you need to replace the filter because it is worn out or damaged you will need to replace the entire vent. view full answer...
For a Furrion Fireplace like the # FF30SC15ABL the 88 error code is caused by inadequate airflow or overheating. Check the inlets and outlets of the fireplace to make sure they are clean and nothing is blocking them. Removing the cover and then the mounting screws will allow you to pull the unit out and access the power cord. Once you unplug it let it sit for 15-20 minutes to reset. If you're using this in temperatures below 40 it will also cause it to overheat since it will run continuously. view full answer...
The outside diameter of the receiver portion for the Hitch Extender for Brophy Hitch-Mounted Stairs # RHSE is about 2-1/2" while the shank portion (that fits in your vehicle's hitch receiver) is about 2". Please note that this was designed to be used with the Brophy Hitch Stairs # RHS2 and hasn't been tested or approved as the base of a bike rack.
If you let me know what bike rack you have I can see if we have a replacement part for it. view full answer...
As you have been hearing a grinding noise on the Kwikee steps on your 2019 Tiffan Open Road Allegro, I would check the Gear Box and A Linkage # LC379160. If you remove the gear box you will be able to actuate the arm and determine if you feel any resistance that may be causing the grinding noise you are hearing. If large parts of the gear or housing are damaged you should hear them inside the case. If you find either of these wrong you will want to replace your gear box.
With the Step... view full answer...
We can tell you how to determine a fit, but there isn't any way for us to know what RVs will fit the Furrion RV Electric Fireplace with Logs - 40" Wide - Recessed Mount # FF40SW15ABL.
In order to determine the fit, just measure the area where the fireplace is going to be mounted. If it is a flush-mounted install into a wall cutout, you'll need a cutout measuring 35-3/16" wide x 15-13/16" tall x 4" deep.
If you are mounting the fireplace into a cabinet for a half-flush mount, you'll need... view full answer...
Your brake controller wiring bundle on your 2022 Tiffin Allegro Bus SHOULD be actually behind the panel to the left of where your left foot would be when driving. I did some digging online and that's where it should be on your motorhome. I was not able to find anything that confirms the connectors you found to be for brake controller wiring but it could be. You would need to verify that with a tester like the part # PTW2992.
One of the wires should have 12 volts all the time, one should... view full answer...
This is partially correct. The Demco Stay-IN-Play Duo Supplemental Braking System w/ Wireless Coachlink Monitor - Proportional # DM86VR installs in your tow vehicle and not in the coach, however it's not compatible with air brakes. Instead of the Stay-IN-Play, you'll want to use the Demco SBS Air Force One system # DM26VR. It will work very similarly and provide proportional braking for your tow vehicle, in a permanently installed braking system.
The wireless CoachLink sends a signal to... view full answer...
For an RV approved e-bike rack with more than enough weight capacity for your 65 lb bikes the Hollywood Racks RV Rider part # HLY64FR would work great. It has an 80 lb weight capacity and is Class A approved. This is a 2 bike rack though and there are no 3 bike configurations for e-bikes. view full answer...
The Front SumoSprings Rebel Custom Helper Springs # SSF-173-40-2 are the correct Springs for your 2018 Tiffin Open Road Alegro 36UA on the Ford F53 GVWR 26,000lb chassis. These have a 3,000lb capacity to assist your suspension in supporting the additional weight on your chassis and will help to reduce road shock and body roll.
The Rear SumoSprings Maxim Custom Helper Springs # SSR-183-54-1 are your correct rear springs for your Tiffin. They have a 7,000lb weight capacity for supporting... view full answer...
The Hollywood Racks Sport Rider SE 2 # HLY74FR is going to be roughly 33" from the center of the hitch pin hole on the shank to the furthest part away from the bike; it does have 7" rise in the shank, but either way you cut it, it's going to be close. The turning clearance is a concern that you're likely going to encounter trouble with, but even if it would put the bike rack above the vehicle's hood I think there are going to be issues with the rack potentially smacking down on the hood... view full answer...
The correct SumoSprings Custom Help Springs for a 2018 Tiffin Open Road Allegro 32SA is part # SSR-183-54-1 for the rear and part # SSF-173-40-2 for the front. view full answer...
The largest rise/drop we offer is the # RM-048-10 from Roadmaster that offers a 10-1/4 inch rise or drop. You want to be within 3 inches plus or minus of level, and this adapter would put you within that range.
If you click the provided link, you can see a product description video featuring the adapter.
This being said, the Gen-Y adjustable ball mount you have looked at # 325-GH-516 would also work well for you, and would allow you to get a bit closer to level. view full answer...
The 7" Hitch Extender # HE06 can be used with the 23x59 Stromberg Carlson Cargo Carrier # CC-100 on your 2022 Tiffin Open Road Allegro class A motorhome. You will need to consider the weight capacity you are looking to carry with your cargo carrier to ensure that it is safe. The Extender # HE06 will reduce your receiver tongue weight capacity by 50% or up to 350lbs(whichever is less). With the carrier weight at 39lbs you will only be able to carry a maximum of 311lbs at most with this carrier... view full answer...
The correct Roadmaster rear sway bar for your 2022 Tiffin Allegro Open Road 34PA with a 26k GVWR is the part # RM25VR. This works with your Liquid Spring suspension setup as well. view full answer...
I wet ahead and checked out the transmitter on the Custer Wireless LED Tow Bar Light - Weatherproof # LIW-LDTL-7B, and was able to find out that this unit gets it's power through the 7-pole on the back of your RV.
So when your RV has power to the 7-pole, and it is plugged in, the transmitter will send a signal to the light. This light does have an 3AH battery which can be replaced/charged that I recommend checking first, and it can be accessed from a panel at the bottom of the light.
The... view full answer...
According to what I was able to find, the 2019 Tiffin Open Road Allegro is manufactured on a Ford F-53 Chassis. The exact sway bar you need will depend on the GVWR of your motorhome, which should be mentioned on the manufacturer's ID plate along with the VIN and other important information.
For 15,700 lb, 18,000 GVWR models less than 34 feet long, use # RM-1139-146 which would install in conjunction with the existing sway bar. For 22,000, 24,000 or 26,000 lbs, use # RM-1139-149. The factory... view full answer...
Go To Results